Home » Categories » Statistics » Capability » Capability Analysis (from Practical Tools for Continuous Improvement)

ST: 4.6. Calculate and interpret the capability indices

Revision Date: 2005-09-07

This step describes the key capability indices.

4.6.1. Calculate Cp.
4.6.2. Calculate Cpk
4.6.3. Interpret Cp and Cpk.
4.6.4 Calculate Cpu and Cpl
 

Practical Tools for Continuous Improvement discusses other indices, such as Cpm and Cr.


  The above article is an excerpt of the "Capability Analysis" section of Practical Tools for Continuous Improvement Volume 1 Statistical Tools.

Attachments Attachments
There are no attachments for this article.
Related Articles RSS Feed
ST: 4.5.1. Find the percentage above the upper specification
Viewed 2197 times since Fri, Nov 9, 2007
ST: 4.1. Sketch the distribution
Viewed 2109 times since Fri, Nov 9, 2007
ST: 4.7. Analyze the Results
Viewed 1894 times since Fri, Nov 9, 2007
ST: 4.2. Calculate the estimated standard deviation
Viewed 2895 times since Fri, Nov 9, 2007
ST: 4.4. Draw the specification limits on the distribution
Viewed 2242 times since Fri, Nov 9, 2007
ST: 4.5.2. Find the percentage below the lower specification
Viewed 2171 times since Fri, Nov 9, 2007
ST: 4.6.2. Calculate Cpk
Viewed 10746 times since Fri, Nov 9, 2007
ST: 4.6.3. Interpret Cp and Cpk
Viewed 11481 times since Thu, Jan 10, 2008
ST: 4.6.1. Calculate Cp
Viewed 6384 times since Fri, Nov 9, 2007
ST: 4.5.3. Determining the total percentage outside the specifications
Viewed 2514 times since Fri, Nov 9, 2007